Installing A Preformed Pond, Pumps & Plants
133 gallons; 74" x 51" x 18"
Positioning the preformed pond. The deck overhang will
hide small birds from Hawks.
Marking & digging the hole. (Found a grounding rod)
Cut the solar panel's ground rod lower, so it can't
puncture the pond
Gradually removing dirt from underneith to sink the
liner evenly, and retain a solid bed
Water weighs down the liner while pushing dirt below
to make a solid bed
Allowing the water to overflow to help pack and settle
the soil beneath it
Our first water plant: a red Iris in a perforated
container topped with pebbles
Tucking burlap around the rim to hide the plastic look
Laying flatish rock around the rim, which begins the
making of a patio
A 210 GPH pond pump in a biological filter kit. The
1/2" hose will carry the water to the trees
About to submerge the pump-filter with hose &
powercord feeding out beneith rocks
The only sign of the submerged pump-filter is its hose
& powercord feeding out beneith the rocks
As the pump waters the trees, the pond filler refills
the pond through a frog spitter
The 1/2" pump hose is not the same size as the 1/2"
irrigation hose. This connector joins them
Running the pond pump hose to a PVC outlet at the
tree, raised to prevent siphoning
Installing an electrical box to power the pond pump
that will water the trees, etc
Running the power line. I will hide it inside the wall
someday when I rebuild the wall.
Tying the new electrical box into the existing
circuitry under the trailer
Attaching an outlet and an outlet enclosure to the new
electrical box
About to install an outlet for a 330 GPH pump & filter
to recirculate the pond water
Preparing to submerge the 330 GPH pump & filter into
the pond
The 330 GPH pump aerates the water very well
Two Brinks 7-day digital timers control the two pond
pumps
Copyright © 2011, Van Blakeman